----+----1----+----2----+----3----+----4----+----5----+----6----+----7----+----8
PARFIL 7375 20000.
----+----0----+----0----+----0----+----0----+----0----+----0----+----0----+----0
COLUMNS FORMAT DESCRIPTION DEFAULT VALUE & UNITS
1-6 A6 Requests output of measurement partial
derivative file(s) on last inner iteration
of each data reduction arc during first
global iteration.
7 I1 Indicates whether each arc should open a 0
new logical unit for output or continue
writing to the same unit as the previous
arc.
0 - Concatenate all arcs providing header
information between each arc.
1 - CLOSE currently open output file at
end of each arc and increment output
unit number for start of each new arc.
2 - ENDFILE currently open output file at
end of each arc. (applies only to IBM
type operating environment for
GEODYN-IIE)
11-12 I2 Indicates logical unit number (NU1) of first 90
segment of file. Maximum segment size is
specified in columns 73-80.
NOTE: 90 .LE. NU1 .LE. 99
If segment size is exceeded, the currently open
logical unit will be CLOSED, the unit number
will be incremented by one and output will
continue.
JUNE 1986
8606.0
GLOBAL SET
PARFIL (cont)
COLUMNS FORMAT DESCRIPTION DEFAULT VALUE & UNITS
11-12 cont. If column 7 contains a one, then the currently
open logical unit will be CLOSEd at the end
of each arc, the unit number will be incremented
by one and output will continue for the next arc.
If column 7 contains a two, then the currently
open logical unit will be ENDFILEd at the end
of each arc, the unit number will remain the same,
and output will continue for the next arc.
13-14 I2 Maximum unit number (NU2) that will be opened Same as cols.
for output of this partial derivative 11-12
file.
NOTE: NU1 .LE. NU2 .LE. 99
25-44 D20.8 Partial derivative file number to uniquely E-Matrix Number
identify the file. or 0. if no EMAT
73-80 F8.1 Number of blocks (of 512 64-bit words) 20000.
of disk space requested for each segment of
the measurement partial derivative file.
A good estimate for the total disk space
required for the entire measurement partial
derivative file may be obtained by multiplying
the number of weighted observations by the
number of adjusted parameters and dividing
by 512.
If outputing to tape, specification of a very
large number here will prevent incrementing
of unit number unless specified by column 7.
IF CARD OMITTED: No measurement partial derivative file will be generated.
JUL 1998
9808.0
GLOBAL SET